DIAMOND SUPREME SHEEN WAX

DIAMOND SUPREME SHEEN WAX is a reinforced protective polishing coating for all Marmorino and Venetian mineral finishing.

DIAMOND SUPREME SHEEN WAX is composed of a mixture waxes suspended in water and solvent. It is a non-film forming that enables treated surface a waterproofing capacity, non-yellowing power and wash-ability resistance. It is suitable for ALL lime decorative plaster.

DIAMOND SUPREME SHEEN WAX increases the glossiness and confers to the surface washable properties, maintaining an outstanding breath through capacity.  It is for interior use.

APPLICATION:

Ready to use, mix carefully before using. Let the surface to dry out for at least 24 hours. Do not apply over tacky surface.

Apply by trowel, thin layer, or by pad or rag. When the wax is well-dried, buff with a mechanical buffer or a soft rag by hand.

Recommended coats: 2 coats

Packaging: Quart

Color: White thick paste - dries clear

SAFETY NORMS

As the use of adequate technical equipment must always take priority over personal protective equipment, make sure that the workplace is well aired through effective local aspiration.
When choosing personal protective equipment, ask your chemical substance supplier for advice.
Personal protective equipment must be CE marked, showing that it complies with applicable standards.

HAND PROTECTION
Protect hands with category III work gloves.
The following should be considered when choosing work glove material (see standard EN 374): compatibility, degradation, failure time and permeability.
The work gloves' resistance to chemical agents should be checked before use, as it can be unpredictable. The gloves' wear time depends on the duration and type of use.

SKIN PROTECTION
Wear category I professional long-sleeved overalls and safety footwear (see Regulation 2016/425 and standard EN ISO 20344). Wash body with soap
and water after removing protective clothing.

EYE PROTECTION
Wear airtight protective goggles (see standard EN 166).

RESPIRATORY PROTECTION
If the threshold value (e.g. TLV-TWA) is exceeded for the substance or one of the substances present in the product, wear a mask with a type AX filter, whose limit of use will be defined by the manufacturer (see standard EN 14387). In the presence of gases or vapors of various kinds and/or gases or vapors containing particulate (aerosol sprays, fumes, mists, etc.) combined filters are required.

Respiratory protection devices must be used if the technical measures adopted are not suitable for restricting the worker's exposure to the threshold values considered.

The protection provided by masks is in any case limited.
If the substance considered is odorless or its olfactory threshold is higher than the corresponding TLV-TWA and in the case of an emergency, wear open-circuit compressed air breathing apparatus (in compliance with standard EN 137) or external air-intake breathing apparatus (in compliance with standard EN 138).

For a correct choice of respiratory protection device, see standard EN 529.

ENVIRONMENTAL EXPOSURE CONTROLS
The emissions generated by manufacturing processes, including those generated by ventilation equipment, should be checked to ensure compliance with
environmental standards.

FIRST AID

EYES: Remove contact lenses, if present. Wash immediately with plenty of water for at least 15 minutes, opening the eyelids fully. If problem persists, seek medical advice.

SKIN: Remove contaminated clothing. Rinse skin with a shower immediately. Get medical advice/attention immediately. Wash contaminated clothing before using it again.

INHALATION: Remove to open air. If the subject stops breathing, administer artificial respiration. Get medical advice/attention immediately.

INGESTION: Get medical advice/attention immediately. Do not induce vomiting. Do not administer anything not explicitly authorised by a doctor.